Make the knob yours.
A few steps now. Simple lighting, every day.
- 1 · Connect
- 2 · Wi-Fi
- 3 · Hue Bridge
- 4 · Your lights
Have your Wi-Fi password and Hue Bridge nearby.
First, plug it in.
Connect the controller to your computer with a USB data cable. Use desktop Chrome or Edge, then choose the controller in the connection window.
- Your Hue lights should already work in the Hue app.
- Use a 2.4 GHz Wi-Fi network that can reach your Hue Bridge.
- Close any serial monitor using the controller.
Light control pauses during setup. Your saved settings stay in place until you choose Save. Cancel or unplug to return to them. Setup closes after ten minutes without a setup action.
Can't connect?
Try a different data cable or USB port. If the controller is missing from the list, your board may need its USB driver. DIY boards need this project's setup-capable firmware first. See the setup guide.
Connect to your home Wi-Fi.
The controller joins Wi-Fi itself. Your computer can stay on its current network.
Say hello to your Hue Bridge.
My bridge wasn't found
In the Hue app, open your bridge's settings and find its IP address. Enter that address above. Make sure the controller and bridge are on the same home network; guest Wi-Fi often blocks them from communicating. A Hue Bridge is required; Bluetooth-only bulbs are not supported.
What should this knob control?
Choose one room, a few rooms, individual lights, or a mix. Everything selected will dim and switch together.
Your knob is ready.
Try a tap and a turn now. Then move the USB cable to a suitable wall adapter. Settings stay saved when you unplug.
Come back to this page to change Wi-Fi or choose different lights. Battery power is a future hardware addition.
Device help
Reading local diagnostics…
Before setup
Live device details
This page works offline. If Wi-Fi is broken, these instructions still work on the controller’s setup network. Nothing is uploaded.
Open this error’s online helpTo load online help, your phone needs home Wi-Fi or mobile data. The help link carries only the displayed fault code.